Azek Rail User Manual download pdf (Page 12)

Page 12

Installing AZEK Rail with CableRail by Feeney

®

40” above deck surface is

optimal for 36” railing heights.

If you do not have a the

template, position

the top of the Support Block 4”

above the deck.

INSTALL LOWER

SUPPORT BLOCK

• Position template at

bottom of post

sleeve above post

skirt.

• Trim Post Sleeve to

desired length.

INSTALL POST

SLEEVE

• Slide Post Sleeve and

Post Skirt over post

(do not force).

• Ensure posts are

square and plumb.

Optimal 40”

45°

For angled rail installations

- align angled face of Support

Block parallel to rail section.

CUT AND ASSEMBLE BOTTOM SUPPORT RAIL

•Cut the Bottom Support Rail to length.

3

1

2

Straight Section

Angled Section

Center screw aligned

to rail centerline

Center screw

aligned to rail

centerline

Bracket set

ush to rail

face

Bracket set

ush to rail

face

Foot Block

7/64” Pre-drill

#8 x 3” Coated

Screws

7/64” Pre-drill

#8 x 3/4” Coated Screws

1/2

1/2

4”

Template

Support

Block

Post

Skirt

7/64” Pre-drill

#8 x 3” Green

Coated Screws

For sections up to 6’: Place one Foot

Block in the center of the rail.

For sections 6’ to 8’: Space two Foot

Blocks approximately at 1/3 intervals on

the rail.

For sections 8’ to 10’: Space three Foot

Blocks approximately at 1/4 intervals on

the rail.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 39 40

Comments to this Manuals

No comments